QSI 520c Betriebsanweisung PDF herunterladen (Seite 15)

QSI 500 SERIES USER GUIDE

Note: The camera power connecter uses a standard 2.1mm coaxial DC power

connector with center positive. Inside diameter 2.1mm, outside diameter 5.5mm,

length 10mm.

Caution: Because of the wide range of potential power sources (especially with

field operations that can also employ batteries, generators, DC inverters, etc.)

there is the real possibility of damaging your camera and other electrical

equipment by creating unexpected ground loops and different ground reference

potentials between your equipment.

It is highly recommended that the included AC adapter be used to power the

camera at all times. If a power source other than the included AC adapter is used,

it is your responsibly to insure that it is suitable. Avoid sharing the camera DC

power source with other devices that can produce excessive noise (old technology

dew heaters, etc.) and possible ground loops that could interfere with the reliable

operation, or even damage your imaging equipment.

If you choose to use a power source other than the included AC adapter and are

uncertain about meeting these requirements, please contact QSI for assistance.

USB Connector

The camera's USB interface is compatible with USB 2.0 and 1.1. The included USB 2.0

cable plugs into the USB port on the camera connector panel. The other side connect

any standard USB port on yo

s to

ur computer. All camera control commands and resulting

ges are passed over the USB cable. ima

Note:

Do not connect your camera to your computer unless you have

successfully installed the camera software and drivers.

After the camera power-up initialization is complete, and the camera's USB cable is

o your computer, the computer will make a Plug-N-Play sound indicating that a

device was connected to the computer. This means that your camera is ready and is

listenin

connected t

g for commands to be sent over the USB connection.

Note: QSI 500 Series cameras do not draw power from the USB bus. Powered

hubs are not necessary for operation.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 81 82

Keine Kommentare

QSI 520c Betriebsanweisung Seite 15