QSI 520c Betriebsanweisung PDF herunterladen (Seite 14)

QSI 500 SERIES USER GUIDE

Electrical Connections

dy to

rotect the connectors when no

cables are attached.

DC Po

The camera is ordinarily powered by the included AC power adapter which plugs into the

le connector on the bottom of the camera. The AC power adapter accepts any input

voltage from 90v to 240v and 50-60 Hz. It is supplied with a region-specific AC power cord.

cator on the back of the

camera will

nected via the USB cable.

The Camera Status Indicator will glow solid green once the camera is connected to the

computer via the USB cable. See the Status and Notification discussion later in this

Section for additional detail.

The image at the left is a close-

up of the bottom of the camera

body. All electrical connections to

the camera are made through the

three connectors located on this

connector panel. The panel is

recessed into the camera bo

wer Connector

midd

Shortly after power is

applied to the camera, the Camera Status Indi

camera will start glowing yellow indicating that the camera is starting up. The

make a small “chirp” sound and then a few seconds later will make a “chirp chirp” sound

indicating that the camera successfully completed its initialization steps. The Camera

Status Indicator will begin flashing green if the camera is not con

Note: Power-up initialization can take up to 6 seconds. It is not possible to

connect to the camera from the imaging application (MaxIm LE, CCDSoft, etc.)

during this time. Any attempt to do so will cause an error message to be displayed

by your imaging application.

Note: The camera is designed to operate on stable, regulated 12V DC power and

consumes less than 2 amps at full power. DC power input above or below 12V

will decrease the maximum cooling capability of the camera by increasing power

dissipation or lowering cooling efficiency. If the input voltage is below 11V or

above 14V the camera will report an error until the voltage is returned to the

specified range. See Status and Notification below.

Caution: Applying an input voltage over 16V or under 10V may

permanently damage the camera and will void the camera warranty.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 81 82

Keine Kommentare

QSI 520c Betriebsanweisung Seite 14